We use cookies to enable all functionalities for best performance during your visit and to improve our services by giving us some insight into how the website is being used. Continued use of our website without having changed your browser settings confirms your acceptance of these cookies. For details please see our privacy policy.
×

How can we scientifically drill a well to find water

Views: 11     Author: pqwt     Publish Time: 2022-10-25      Origin: PQWT


Adopting scientific well drilling process: To make a well with high water output, low depth of drop, good water quality and long service life under the same geological conditions, it is crucial that the well formation process is scientific and reasonable. Here's how to drill a well scientifically to find water with the pqwt institute

ground water detector

1. The filter pipe should be right on the aquifer


Once the two are misaligned, the resistance to incoming water will be much greater, thus increasing the depth of descent. For this reason, we should physically probe the well before placing the pipe to accurately determine the aquifer location.


2、The porosity of the filtering water pipe should be sufficient


No matter what pipe opening porosity should not be less than 10%. Most of the cement pipes produced by domestic methods are only 1-2%, and the water inlet resistance is very high, which is not allowed.


3, the filter water pipe and the filter network should be added between the pad tendons


If there is no pad tendon, the strainer will stick to the well pipe, and only the strainer facing the inlet hole can be fed, which will easily cause blockage and seriously affect the water output and service life of the well.


4. The mesh of the screen and the size of the filled gravel should be adapted to the aquifer


Otherwise, either blockage, or muddy water caused by well water.


5, mud drilling, break the wall for slurry before releasing the pipe.


When drilling with mud, use the wall-breaking pipe to take the mud first.


At present, there are serious problems such as random configuration of filter water pipe, low opening rate of filter water pipe, no reinforcement, unqualified filter mesh and gravel filling, incomplete wall slurry replacement, etc., which need to be improved. Most of the recharge wells of ground source heat pump are not well recharged, which is an important reason.


Conduct pumping test, reasonable pump selection


The pumping test can be combined with well washing. Before the end of well washing, measure the water output of the pump, static water level, dynamic water level, and calculate the unit water output of the well, the possible large water output, and the appropriate water volume for the pump. At present, the vast majority of wells do not have the above data, only know a few kilowatts of water pump is enough to pump water, can only blindly choose the pump, well drilling how deep to choose a high head of water pump, a serious waste of energy.


The use of pqwt physical ground water detector significantly improves

ground water detector

The principle electric detection method used by the physical ground water detector is divided into artificial electric field method and natural electric field method. The instrument can observe multiple frequencies of electric field signals, in the hardware design and software development using a variety of reliable technology, so that the ability to resist interference and the stability of the system has been enhanced. The instrument adopts multi-channel multi-mode data acquisition, and automatic analysis and processing of the collected data, real-time data saving and plotting graphs, through the graphs to find out the broken zone. pqwt new generation ground water detector has the characteristics of easy to carry, simple operation, automatic map, high accuracy, and its equipment has won a number of invention patents and software copyrights.